Just wanted to say thank you for being so responsive and taking the matter so seriously.
If you are in a dialog with engineering I would point out that a enhancement to the traceability report would be if you could move the Arrow showing the parts under a subassembly just a bit to offset it from the previous subassembly.
Like this.
That is much more readable than the flat one like this
I do not know if that is doable as I do not know how you cycle through the data.
Also I would like to ask why not all parts that are on the same level is shown together.
So if you look at this.
You can see that the
SNC parts has only 2 arrows depicting that it is a subpart of the SNC product.
and the PCH parts has 3 arrows depicting that it is a subpart of PCH … and so on
It would be nice that it kept all the subassemblies together in the traceability report.
So all 1 arrow > parts where listed first
And then all 2 arrow >> parts second… and so on.
That would greatly improve the readabliity of the report.
Especially if you like me have tried to list all the parts in that order in the BOM’s.
I know it might be asking a lot but please consider it.
once again thanks!
//H